News:

           Enjoy your FJ


Main Menu

Alternator

Started by winddancer, March 14, 2013, 01:01:51 PM

Previous topic - Next topic

winddancer

I was checking my alternator this last weekend and at 3000 rpm it is reading 15.9v at the battery is this to much and do i need to to do the regulator upgrade? My worry is i have the new lithium battery and i don't want to fry it.

Mark Olson

check all your grounds and connectors first . then do it.
Mark O.
86 fj1200
sac ca.

                           " Get off your ass and Ride"

winddancer

if i had a bad ground it would read high at the battery?

Mark Olson

yeah , it don't know how many volts to kick out.
Mark O.
86 fj1200
sac ca.

                           " Get off your ass and Ride"

fj1289

Here's something from Hippy Cain I copied - fairly recent post so you can probably search for the original thread.

"Another thing you can do to extend battery life is to check the voltage at the alternator. Over charging a battery will harn it quickly. The smaller red wire that goes to the alternator supplies the field voltage. If this voltage reads low (it will because it passes through the main switch, and several connections) you will need to clean the switch contacts and connectors. The other fix is to use a relay to supply full battery voltage to the alternator and use the original circut to activate the relay.  My 89 was overcharging it's battery all the time because the reg/rec was always seeing a false low voltage. I have installed a nice Bosh 30 amp relay, a 15 amp blade fuse and some 10 gauge wire and it now works fine."


winddancer

thanks i will check it out this weekend

Mark Olson

Is somebody poking pins in my voodoo doll ? cause now I have a voltage problem. geez  :dash1:
Mark O.
86 fj1200
sac ca.

                           " Get off your ass and Ride"

winddancer

Quote from: Mark Olson on March 15, 2013, 01:22:34 PM
Is somebody poking pins in my voodoo doll ? cause now I have a voltage problem. geez  :dash1:

Not my fault I swear  :wacko3:

winddancer

Found the connector was melted together so I fixed that and will retest tomorrow