rpm's drop

[racerrad8]

Should be 2nd groove from the top.... you're too rich on the needles.  

Rich,
         The needles I supply are the O.E. profile needle with the adjustable slots. As seen in the picture below;


You can see the stock needle position is the center position. So, by raising the clip up the needle range mixture would be leaner than stock.

I set it on the 2nd down from center.

Will, if you are at the bottom groove, you are probably too rich.

Randy - RPM

[SlowOldGuy]

Murphy's law # 2    ..... the last thing you touched is probably the thing causing you trouble.

Frank,
That's Hoffman's Law #2.  Every time he calls me with a problem, my first question is: "What was the last thing you fixed before the problem started?"

DavidR.

[RichBaker]

Should be 2nd groove from the top.... you're too rich on the needles.  

Rich,
         The needles I supply are the O.E. profile needle with the adjustable slots. As seen in the picture below;


You can see the stock needle position is the center position. So, by raising the clip up the needle range mixture would be leaner than stock.

I set it on the 2nd down from center.

Will, if you are at the bottom groove, you are probably too rich.

Randy - RPM

Didn't realize that....

[racerman_27410]

Murphy's law # 2    ..... the last thing you touched is probably the thing causing you trouble.

Frank,
That's Hoffman's Law #2.  Every time he calls me with a problem, my first question is: "What was the last thing you fixed before the problem started?"

DavidR.

LMAO..... i dont want to give Jefman too much credit but you are absolutely right in that he fits the description perfectly.

KOokaloo!