News:

           Enjoy your FJ


Main Menu

pick up sat

Started by elbows, September 18, 2009, 11:23:31 AM

Previous topic - Next topic

elbows

well saturday i am off to fetch my next project in the morning 1200 yamaha 3cv but its all in bits so should be fun will post pics when i start and hat state its in and start making list
old racers never die  its the stories just get faster

3 bikes all 3cv

elbows



this how i picked my next project up
old racers never die  its the stories just get faster

3 bikes all 3cv

elbows



it might be lots of fun sorting this out
old racers never die  its the stories just get faster

3 bikes all 3cv

higbonzo

Holy crap!?!   You are going to have a new bike when you get done putting that all back together.   So, what is the your ETA on this bad boy?

Later..... :bye2:

paulfj03

cool, elbows.......  youre going to need some "elbows' grease"  for that!!! :sarcastic:



elbows

few more pics



most of the stuff put away


engine a little dirty  think i have got some work to do
old racers never die  its the stories just get faster

3 bikes all 3cv

andyb

Got yer work cut out for you!

I'm entirely envious of your lift though, that'll make it a load easier.

Dan Filetti

There was a line in the book, "Zen and the Art of Motorcycle Maintenance" about a guy picking up a Hardley in pieces like this.  The narrators' perspective was that he'd know just about all there was to know about the bike once he had it assembled.

And so will you.

Have fun!

Dan   
Live hardy, or go home. 

rossco

 1st fridge+beer. Any mods e.g.swingarm?  Have fun.

elbows

some pics from inside the motor






my 3cv also was full of crap as well and it ran very hot after the filter was cleaned out did not get hot again
old racers never die  its the stories just get faster

3 bikes all 3cv

Dan Filetti

Do you intend to replace the shift forks, and undercut second gear while the motor's out?  Seems like it would prudent, unless you know it's already been done.  Be a shame to have to pull the motor once it's in and running. 

Dan
Live hardy, or go home. 

elbows

Quote from: Dan Filetti on September 21, 2009, 08:41:41 PM
Do you intend to replace the shift forks, and undercut second gear while the motor's out?  Seems like it would prudent, unless you know it's already been done.  Be a shame to have to pull the motor once it's in and running. 

Dan

hi dan no problem with the gearbox or clutch so i think a good clean check the top end poss will chat to last owner
old racers never die  its the stories just get faster

3 bikes all 3cv

paulfj03

Thank you for the pictures and the updates, elbows...

paul

elbows













some repairs and a fare bit of cleaning etc lots more to do will post more pics
old racers never die  its the stories just get faster

3 bikes all 3cv

europe50

Is that gunk (pieces) in the oil pick-up a common in these bikes?