cdi wiring

[fjman]

 I do not know where the 3 wires go to (white,gray,black) the dog chewed the connections on my engine.  labradors and fjs do not mix 



I marked the cdi 1234 so you guys can help me better.
I'm also not getting any spark from the coils. All 4 spark plugs are new. The battery works fine. The starter motor spins fast. Ive also checked my wiring connections. i also soldered other wiring connections.(including the oil and neutral sensors which the F*CKING dog chewed ) The oil and neutral sensors work fine now.
any help would be appreciated 

[fjman]

It's a 1984 yamaha fj1100

[gp1]

hi the wiring diagram for us and uk model shows you should have a black orange and grey.
i checked on my 84 uk model and have the same colours.
on the picture of the ingnitor unit you have shown the orange is no1 black no2 grey no3- no4 blank,
these all go to the pick up coil.

hope this helps
gp1

[fjman]

thanks i'll look into it tomorrow.. If I place the wires on the wrong position. Is there a tendency that I will fry the cdi?

[fjman]

C'mon guys, take a look at your FJ's it won't take long.. need some help here 

[VMS]

I can't help too much with colors, as I make my own wiring harnesses for the Legends cars, but the grey wire on the pick-up goes to your #1, and the black goes to your #2. If you have eliminated the vacuum advance, those are the only 2 wires, 3 & 4 are blank. If you still have the vacuum advance:

1  2
  3
(1 & 2 being the 2 parallel connections)

You would have a wire from your #3 to vacuum #2, and a wire from your #4 to vacuum #1.

Hope that helps a little

Jim

[fjman]

hi the wiring diagram for us and uk model shows you should have a black orange and grey.
i checked on my 84 uk model and have the same colours.
on the picture of the ingnitor unit you have shown the orange is no1 black no2 grey no3- no4 blank,
these all go to the pick up coil.

hope this helps
gp1

thanks for the help. 
it sparks now