Abs module removal

[Cruzncycles]

Hello Nick here
I have a 92 fj1200a
I'm in the process of rebuilding her
She sat outside for 12 years in Florida
I have replaced the brake and clutch master cylinders with cotra corsa brembo controls running single cable to each front blue cap caliper
1 single cable from rear master to stock caliper ( haven't really found any info on rear caliper swaps)
Just curious on the removal of the abs system
I'm a licensed electrician and have worked on older 4 banger yamahas for years

I see that the fuel pump pulls from a relay shared with the abs module
As long as that relay stays I can pull the module and everything should be fine? Just cap off the signal wires from the masters to the module (br/g&br/bl)
O/w are the speed sensors front and rear figure those can go cause the speedometer isnt run off those wires.


So can I just pull it and the fuse for it and everything be fine?

Also any info or rear caliper upgrades.

I order all of my new parts from Rpm those dudes are the best!!!

[FJmonkey]

Nick, try some Google searches with "Fjowners.com ABS removal". This has been done and posted.

[Cruzncycles]

Thank you think I got it sorted. Do you know of any direct swaps for the rear caliper?

[Pat Conlon]

All FJ rear calipers are interchangeable.

https://www.partzilla.com/product/yamaha/4BH-2580W-01-00  select "Product Fitment".

You can change the brake caliper if you change your back wheel assembly. e.g. YZF1000 Thunder Ace or GSXR, etc.

Example: