News:

This forum is run by RPM and donations from members.

It is the donations of the members that help offset the operating cost of the forum. The secondary benefit of being a contributing member is the ability to save big during RPM Holiday sales. For more information please check out this link: Membership has its privileges 

Thank you for your support of the all mighty FJ.

Main Menu

DIY gauge to check float heights

Started by pict, August 05, 2021, 11:05:51 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

pict

August 05, 2021, 11:05:51 AM
Made this gauge to check the float heights. Just found it easier to hold and see what was going on than using the depth gauge on a caliper (especially as regards slightly twisted float assemblies). Instructions and template posted in the Carburetor Files child board of the Files Section.
1986 FJ1200 1TX
Print
Go Up Pages1
User actions