News:

This forum is run by RPM and donations from members.

It is the donations of the members that help offset the operating cost of the forum. The secondary benefit of being a contributing member is the ability to save big during RPM Holiday sales. For more information please check out this link: Membership has its privileges 

Thank you for your support of the all mighty FJ.

Main Menu

clutch push rod

Started by Stevecampy, July 24, 2021, 04:59:32 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Stevecampy

July 24, 2021, 04:59:32 PM
Hi just got a fj and clutch seals where shot .so when i was doing them noticed the clutch push rod looks broken about 3 inch from the slave cylinder end is this normal. If it isnt how do i check if the ball bearing is in  there Thanks
 :Facepalm:

FJmonkey

#1
July 24, 2021, 05:53:27 PM
Broken in two, or cracked? The ball is most likely still there. Even when the engine is started with the clutch slave removed, and the pushrod is shot out (spearing the cat) the ball tends to say in.
The glass is not half full, it was engineered with a 2X safety factor.

'86 Ambulance - Bent frame, cracked case, due for an overhaul
'89 Stormy Blue - Suits my Dark Side

Stevecampy

#2
August 09, 2021, 03:17:19 AM
Been in and had a look clutch basket only had three bolts  all others thread stripped this bike has been butchered .new clutch rod and mushroom end clutch seams to work with a new basket. :Facepalm:
Print
Go Up Pages1
User actions