News:

This forum is run by RPM and donations from members.

It is the donations of the members that help offset the operating cost of the forum. The secondary benefit of being a contributing member is the ability to save big during RPM Holiday sales. For more information please check out this link: Membership has its privileges 

Thank you for your support of the all mighty FJ.

Main Menu

Fitting Galfer clutch lines

Started by cclase, April 17, 2016, 02:31:04 PM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

Firehawk068

#15
May 03, 2016, 08:04:16 AM
Quote from: Capn Ron on May 02, 2016, 09:31:49 PM
My Galfer setup was also end-to-end for the clutch side of things...eliminating the hard line in the middle makes the most sense to me.

That is what I did also. I used the one-piece line from the master to the slave.
Alan H.
Denver, CO
'90 FJ1200
Print
Go Up Pages 1 2
User actions