does anyone have a spare large plastic fork cap that they can part with??
Fred
Is it time to 3D print these as well?
Quote from: FJmonkey on September 04, 2020, 11:36:49 AM
Is it time to 3D print these as well?
Here is a file already made for the caps and the late model air scoop bumpers.
https://www.thingiverse.com/ihumanist/designs (https://www.thingiverse.com/ihumanist/designs)
Fred
Hey Fred I think I have some on some old forks in storage unit, will run by there tomorrow & check :drinks:
Hi, Fred
If you dont find any there, PM and I send you one from Spain
Fred, are the ally RPM caps (below) any use to you, I have a pair you can have for postage.
(https://www.rpmracingca.com/prodimages/large/M%20C%20HandleBarRiser-1.jpg)
Noel
Quote from: ribbert on September 05, 2020, 07:50:33 AM
Fred, are the ally RPM caps (below) any use to you, I have a pair you can have for postage.
(https://www.rpmracingca.com/prodimages/large/M%20C%20HandleBarRiser-1.jpg)
Noel
Thank you for the offer. The aluminum caps will not work for unless you use the risers.
Fred
Fred check your PMs.
Thank you all for the replies. A member had a spare and is sending it to me.
Fred