I have pin holes at the top of 2 of my rubber membranes and I found the posts about the ways to patch them. One is to mix 50/50 Naphtha and plastic dip/ liquid electrical tape and the other is straight dip w/ a Q-tip. The liquid electrical tape is pretty thick is the first option of mixing the better way to go???
LA Mike
just did mine and was ready to mix 50:50 but the plastidip seemed fluid enough (i had a spray can). I q tipped a few test coats on without apparent problem, so thats what I did...
Quote from: fjrpierre on March 30, 2010, 03:53:46 PM
just did mine and was ready to mix 50:50 but the plastidip seemed fluid enough (i had a spray can). I q tipped a few test coats on without apparent problem, so thats what I did...
I saw that it comes in a spray, did end up spraying them?, did it come out in a thick & hvy or a mist? Hanging them up and spraying them would make the job so easy.
no i sprayed a bit on a piece of plastic and used a q tip to scoop up and dab on