FJowners.com

General Category => Maintenance => Topic started by: shudnobetter on September 12, 2017, 03:52:22 PM

Title: Carb balancing - connecting vacuum guages
Post by: shudnobetter on September 12, 2017, 03:52:22 PM
As a relative newbie I'm learning as I go.

My question is where exactly do I connect the vacuum hoses from a vacuum manometer on my carbs (1990 3cv)?

Thanks in anticipation.
Title: Re: Carb balancing - connecting vacuum guages
Post by: Flynt on September 12, 2017, 09:18:44 PM
Quote from: shudnobetter on September 12, 2017, 03:52:22 PM
As a relative newbie I'm learning as I go.

My question is where exactly do I connect the vacuum hoses from a vacuum manometer on my carbs (1990 3cv)?

Thanks in anticipation.

Connect to the barbs between the carbs and the engine on the intake boots...  You should have 3 of the barbs capped off and one with a hose going to the control box.  Remove the caps and the hose, attach your vacuum gauges and get busy...

Frank
Title: Re: Carb balancing - connecting vacuum guages
Post by: PaulG on September 12, 2017, 09:34:48 PM
The carb manifolds on the inlet ducts for the motor have a vacc spigot sticking straight up. They should have a rubber cap on them - usually with a spring clamp.

This is a pic from my FJ600 which shows them . The 1200 is the same set up.

Title: Re: Carb balancing - connecting vacuum guages
Post by: shudnobetter on September 13, 2017, 01:30:16 PM
Quote from: Flynt on September 12, 2017, 09:18:44 PM
Quote from: shudnobetter on September 12, 2017, 03:52:22 PM
As a relative newbie I'm learning as I go.

My question is where exactly do I connect the vacuum hoses from a vacuum manometer on my carbs (1990 3cv)?

Thanks in anticipation.

Connect to the barbs between the carbs and the engine on the intake boots...  You should have 3 of the barbs capped off and one with a hose going to the control box.  Remove the caps and the hose, attach your vacuum gauges and get busy...

Frank

Great, thanks. All 4 are capped (may be different specs US/Europe) but they're obvious enough.
Title: Re: Carb balancing - connecting vacuum guages
Post by: shudnobetter on September 13, 2017, 01:32:04 PM
Quote from: PaulG on September 12, 2017, 09:34:48 PM
The carb manifolds on the inlet ducts for the motor have a vacc spigot sticking straight up. They should have a rubber cap on them - usually with a spring clamp.

This is a pic from my FJ600 which shows them . The 1200 is the same set up.



Perfect...couldn't be more clear. I was guessing that was them but needed to be sure. Delighted I don't need that wretched airbox out again!