Just pulled fairings and side panels off again ready for purchase of wiring loom and noticed this box it was double sided taped to the right hand side of the battery box wires going up to headlight at opposite end has one male and one female 3 pin light plug disconnected st light and plugged in light plug on main loom and bike started and light works as normal
So to say I am confused at the moment is a major understatement :scratch_one-s_head:
Any help would be much appreciated
Sounds like a ballast for a HID conversion bulb to me .
Take out headlamp bulb and see if its a standard halogen H4 that will tell you
Could not tell you for sure as I replaced the bulb when I got the bike bout 2 yrs ago as the light it was producing was crap
Quote from: N Z FJ1200 on June 11, 2016, 08:56:17 PM
Just pulled fairings and side panels off again ready for purchase of wiring loom...........
Before you spend a lot of money and time on a new loom, a loom is just the wiring that connects all the components, not the components themselves. It is highly unlikely the gremlin you're looking for is hiding in the wiring.
Noel
Good advice Noel but do you really think a Kiwi is going to listen to an Aussie? :biggrin: Dave
Quote from: TexasDave on June 12, 2016, 07:36:33 AM
Good advice Noel but do you really think a Kiwi is going to listen to an Aussie? :biggrin: Dave
You can always tell a Kiwi, but you can't tell him much. :biggrin:
Noel
:flag_of_truce:
Ok Noel I'm all ears my current wiring loom is a Japanese domestic market loom I had replaced the speedo from a 180k to a 260k now the bike won' t rev out past 6g have stripped wiring down and eradicated all speedlimiter wiring to igniter